Skip Navigation
InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)MR
MrSlicer @lemmy.world
Posts 3
Comments 174
Artme-3D filament extruder
  • Now add in the price of the machine and you will need a way to dry the pellets if you don't use it immediately. I really want this to be a thing but I just don't see it being economical.. It might be fun however to make custom filaments.

  • Artme-3D filament extruder
  • Seems like a total waste. That buys a tremendous amount of filament. I don't think even print farms do it. There are so many filament companies out there that the margins have to be razor thin.

  • *Permanently Deleted*
  • Doesn't copilot do this? I'm just learning now but it's so much easier to code even with Bing Ai chat it helps me understand error messages and all sorts of stuff. What do professionals use?

  • *Permanently Deleted*
  • It codes pretty well for what I need. It helped me write a program for my esp32 to fill out a Google form to populate a Google sheet with temperature humidity and barometric pressure.

    Its also helpful me with a visual basic program that checks on 3 temp/humidity sensors in my home. Plots it on a graph and turns on my led lights to a blue and white animation if the temperature falls below the trigger temp. This warns me if it's close to freezing in my garage. I'm doing my best and trying hard to learn.. Ai has been fundamental in me avoiding hours of googling because I don't quite understand the syntax yet.

    Here's the program in action let me know what you think. It's the first real program I've made. https://youtu.be/T7RhQKH-b70?si=fTgq4_D2w33rGM_2

  • marlin input shaper off and on test.

    I have every setting turned all the way up speed/accel/jerk is only limited by the power limits on the steppers. In the firmware speed is set at 300mms same with on prusa slicer. I just added zeros to the accel and jerk both in firmware and in the slicer. It's an ender 3 with an skr V2 Rev b board and a generic 2 into 1 hotend.

    1

    I made this 2 piece tpu case for telescope lenses.

    This was a very long couple of prints over 30 hours combined. It's for an Orion telescope that's why the Orion drawing.

    7