Got my early Christmas present. I hope I like it.
Got my early Christmas present. I hope I like it.
Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.
May your highs be high and your lows short and with minimal frustration! Good luck!
Nice! I've had my revo nozzles for a few months now and really love the quick swap
Assuming my experience is everyones, you will like it. Don’t spend too much time on the thermal model, though. If you get it to work, great! If you don’t, there’s no shame in just turning it off.
Apparently the 3.13 fw supports the Revo now, so we'll see.
Update: Flashed the 3.13.2 Revo fw and new fw isn't working for TM calibration... going through the troubleshooting steps on github
Update 2: got it working with suggestions on the github. Had to manually send some codes to the printer through octoprint to get a TM set up.
I might just be a cheap bastard, but why not get a CoreXY for that price?