You're viewing a single thread.
iPhone batteries are already pretty easy to replace. I’ve done it dozens of times for several different models. It requires two screws, a bit of heat and a suction cup, then a couple more screws and some pull tabs. Usually takes under 30 minutes to do.
I don’t know how you could make it much easier while keeping the waterproofing. Rossman is a highly opinionated guy and I appreciate his advocacy, but he also makes no attempt to be fair to the product designers and is very biased.
If Fairphone can do it, I would think a company valued at like 3 Trillion dollars could do it...
Fairphone 4 isn't IP68 though, it's IP54. I personally don't care much about waterproof vs water resistent, but let's not pretend these two ratings are identical.
Yeah well, my dad's phone is an IP69 and it can beat up your dad's phone
It’s not as waterproof as the iPhone. Also likely made of entirely different materials.
The main thing for me is the quality of the pull tabs. It might partly be a skill issue but in my experience they break 3 out of 4 times, and then it transforms into a miserable experience. I’ve changed iPhone batteries maybe 6 or 7 times now and I’ve never managed to get better at it, even by being super careful.
They need to find a better system to stick those batteries, at this point I’m convinced pull tabs are terrible by choice.
I’ve never had this issue, but I pull them pretty slowly
I’ve had lots of luck removing them, but I’m usually very patient with the pull. Slow, relatively level pulling with the end wrapped around my tweezers twice always seems to work. I think I’ve only snapped one out of dozens, and a dropper of IPA dissolved the adhesive in a couple seconds, so it wasn’t that big an inconvenience in the end.