Yeah they're a bit of an investment, but for how many years I've used mine it's been worth it.
I also have a few vintage Stanleys and they'll do the job just fine. Often have to weigh out the cost vs time spent restoring.
Tools from Veritas/Lie-Nielsen/etc, make my shop time more enjoyable (they work exceptionally well and feel great in hand) which is a big motivator for me to get in there and finish projects. And I like supporting domestic tool makers when I can, much to my wallet's chagrin.
I "cheaped" out and got the LAJ from Stanley (the Sweetheart No. 62). I think Rex Parker(?) on YouTube had a good comparison of a lot of the "fancy" low angle jacks (as did a million other people). I settled on "good enough". I do this for fun, and so far that plane has been quite fun and easy to use. I love low angle jacks now.
Worked awesome out of the box, then even better after sharpening it. I made a pretty amateur mistake of leaving it on a piece of wood I had just planed. I oiled it before I left for the night, but when I came back in the morning I had the teeny tiniest spots of rust.
I stopped woodworking because of the noise and the dust, and the kickback I got from the router once that scared the woodworking out of me. Stupid, I know. I'm now saving up for hand tools and your work is inspiring!
Not stupid at all. Makes total sense a really bad experience would put you off it.
I had a lot of fun doing all the research to figure out what to buy. Your best bet is to pick a project, then break that project down into parts, then buy the tools you need to do the first few parts of the project. It's a good way to get you woodworking asap for the least amount of money and keep you from wasting too much money if you lose interest. You can buy the tools for the next part of the project when you get to it