Stable Diffusion @lemmy.dbzer0.com Rangelus @lemmy.nz 1y ago

Can't figure out how to add new models to docker install of Automatic1111

Hi guys,

I used the Docker install from here. It was easy to get Automatic1111's web interface up and running, but I'm trying to add new models and I can't figure out how to do it.

I've created a /data/StableDiffusion folder (which didn't exist), and added model files from /data/models, with no effect. I've added them to /data/models/stable-diffusion (which already exists), with no effect. Is there another location where the files are stored? Do I need to do something else to get them to work?

ETA: Discovered I was using the wrong file type (.pth) instead of the correct one (.ckpt). When I tried it with that file type it works perfectly. Thank you everyone for your quick responses and help! Y'all were way faster and more helpful than Reddit!

28 comments

It seems like you are missing a volume mapping from your PC to your Docker. The way it works is that you would put the inside the folder on your PC and it would automatically appear in docker. Could you provide the command you are using? Or if you are using docker-compose the docker-compose.yml?
- I used the command to install DS found on the git page
  
  docker compose --profile download up --buil
  
  And then to run Automatic1111 I used the following command
  
  docker compose --profile auto up --build
  
  You should put your models inside the folder model/StableDiffusion that is in your host machine.
Just to be thorough, does your docker run command / docker-compose have a volume field or flag to link your folder from your host to the container? Or are you making these folders from within the container?
- Forgive me for not knowing the details here, I've never used Docker before so I'm just following the guide.
  
  I first created a folder, then I cloned the git repo to it. Finally, from the command prompt, I ran the install command from within the folder.
  
  [docker compose --profile download up --build]
  
  Show me your docker-compose.yml contents. Won't be able to reply until later in the morning. But I should be able to help you get set up.
I've never used the docker version, it's been easier to use the installer zip.

Have you tried refreshing the list of models?
- I did after each attempt.
  
  Using the installer zip, can you just drop model files into the correct folder and have them work? If so, I may have to just use that version instead.
  
  Yes, after it's installed you can just shove the safetensors etc into the folder and they show in the list after refresh.
Searching through the issues, this seemed relevant:

there are a couple of complicating factors.. One is that all the different modules (stable diffusion, esrgan, realesrgan, clip, blip, codeformer, etc..) have their own functions to download models and their own preferred places to save them, and currently not all of them are configurable. Would be nice if they could be changed so they look in models// so just the models dir could be mapped to the host file system and kept outside the image.

Source link

So it reads like it’s going to be dependent on the module and all of the module’s specific nuances.
- module or model? Because for models it's blindingly easy.
  
  I'm trying to add different models, not modules.
- Arg, I didn't spot that. That's frustrating. Thanks

28 comments