Skip Navigation

NAT and Port Triggering

To increase the security of my NAT configuration, I opted to implement port triggering instead of the traditional port forwarding on my router. I chose this approach in order to configure it from my nix configuration.

Specifically, I have enabled port 443 triggering on my router and included the following configuration:

 nftables = {
   enable = true;
   ruleset = ''
     table ip nat {
       chain PREROUTING {
         type nat hook prerouting priority dstnat; policy accept;
         iifname "wlp2s0" tcp dport 443 dnat to 10.100.0.3:443
       }
     }
   '';
 };
 nat = {
   enable = true;
   internalInterfaces = ["lo"];
   externalInterface = "wlp2s0";
   forwardPorts = [
     {
       sourcePort = 443;
       proto = "tcp";
       destination = "10.100.0.3:443";
     }
   ];
 };

Now, after rebuilding, it still does not work and I'm left to wonder why. Are both the NAT and nftables settings even meant to run at the same time?

2

You're viewing a single thread.

2 comments